DIY PJ Masks Costume

If your kid(s) is/are into the Disney Channel TV show “PJ Masks”, then you’ve likely encountered the same thing that I have: it’s hard to find clothing inspired by the show. If you’ve been looking everywhere for a green “Gekko” costume and haven’t had any luck, then here’s a tutorial for you.

Surf over to the official PJ Masks website for a great 3D view of the characters, including Gekko. There are also downloadable masks, bracelets, and a tutorial for Gekko gloves.

MATERIALS

– medium green hoodie that fits your kid (wash and dry as per manufacturer’s instructions)

– dark green or black fabric marker (I used STAINED by Sharpie)

– light/lime green felt or fleece

– fabric glue

– green thread, needle (optional)

– scissors

– long ruler or straight edge

– glow in the dark fabric paint (optional)

1. Lay the hoodie down on a table and smooth the front out as much as possible. Use the ruler and fabric marker to draw lines across the front of the hoodie at an approximately 45 degree angle with about 1 inch (2.5 cm) between the lines. Once you have covered the front of the hoodie with lines in one direction, turn the ruler 90 degrees and repeat the process in the other direction, covering the front of the hoodie with a lattice of diamonds. Repeat this on the back, sleeves and hood until the entire hoodie is covered in the diamonds. Step back and admire your beautiful Gekko “scales”.

2. From the fleece/felt, cut out the following pieces:

a. Gekko logo approximately 8 inches (20 cm) wide (I made a stencil by printing the logo off the internet and cutting it out)

b. three circles approximately 2.5 inches (6 cm) in diameter (trace a glass or other circular object)

c. two ovals (hockey rink shape) approximately 2 inches by 3 inches (5 cm by 7.5 cm) (I cut one out and traced around it to get the second one fairly similar)

d. two ovals with one short side squared off approximately 2 inches by 3 inches (5 cm by 7.5 cm) (I cut one out and traced around it to get the second one fairly similar)

3. Use the fabric marker to draw two lines across each of the four oval pieces the short way, evenly spaced. Glue the squared off ovals onto the shoulders of the hoodie with the straight edges towards the hood. Let the glue dry thoroughly. You can also sew around the edge if you like.

 

4. Glue the ovals onto the elbow areas of the sleeves, with the oval going lengthwise on the sleeve. Let the glue dry thoroughly. You can also sew around the edge if you like.

5. If the hood doesn’t have a center seam running front to back on it, lay the hoodie on its side and flatten the hood so that you can find the center and mark it with pins or small marks. Lay the hood so you can see where the center line is and place a fleece/felt circle centered on that line. Sew and/or glue the circle to the center line ONLY WHERE IT TOUCHES THE CENTER LINE a little way back from the front edge of the top of the hood.

Leave a space and attach the next circle the same way. Leave another space and attach the final circle. Allow the glue to dry thoroughly.

6. Apply glue to the top of the circle and fold it in half onto itself. Sew the edge if you like. I used binder clips to hold it while the glue dried. Repeat for the other two circles and allow the glue to dry thoroughly.

7. If you want the Gekko logo to glow in the dark, paint the front of it with glow in the dark paint. If you plan to sew it to the front of the hoodie, it’s probably easiest if you paint it after you sew it on. Glue (or sew) the logo to the front center chest area of the hoodie. NOTE: If the hoodie has a zipper, you’ll have to cut the logo in half first.

DONE!